Investigating the bedding of the barreled action to the stock for a Remington 700
Updated: Jan 9
Usually, you would want a more permanent solution when bedding your barrel and action to the stock. However, Mock bedding can be done with epoxy and provides a semi-permanent solution if you wish to try this yourself. A rifle with no bedding at all may give the shooter wider shot groups at a distance and that is because the rifle’s barrel is able to move as the shot is taken. This wobble may begin to occur before the bullet exits the muzzle. This can cause the muzzle to move in many different directions and prevent the shooter from creating a tight shot group. Mock bedding with epoxy would be considered a semi-permanent solution because it will fill those gaps between the rifles stock and the barrels locking lug. Find the spot on the stock where the barrels locking lug fits into and apply epoxy. Press in the barrel and action into the stock firmly to ensure bubbles are pushed out and a tight fit is achieved and allow time for the epoxy to cure. The reason this is considered semi-permanent solution is because once done it will hold very well but if the rifle is completely disassembled then once put back together the barrels locking lug will not be as secure as it was before, and you may need to repeat the epoxy bedding process again for a tight fit.
Want to read more?
Subscribe to freestatetrainingacademy.com to keep reading this exclusive post.




